Featured
Maple Sap Vacuum System
Maple Sap Vacuum System. The 5/16 lines are where most of the damage occurs as they are longer and their size makes them more attractive to animals. Most maple farms are pumping at extremely high vacuum levels, up to 28 in hg.

The sap remains in the chamber for volume measurement and sampling until it was manually emptied. I have nine lines wit. The requirement typically needed in a vacuum is 23” to 28” hgv.
The Yield Is Much The Same As Collecting Sap In A Bucket.
Considering it takes about 43 gallons of sap to make 1 gallon of maple syrup, most farmers find the system a significant improvement. The requirement typically needed in a vacuum is 23” to 28” hgv. It is then piped to the boiling pans where it is concentrated into maple syrup.
When Using Tubing, Can Do More Taps And Get More Sap Per Tap If You Use Vacuum;
Our s4 diaphragm pump controller system allows you to increase your sap yield without manual intervention! With sap yields being less and less reliable, however, many in the maple industry are employing industrial vacuum systems to bridge this gap and draw more sap from the trees. Unfortunately, at such a high vacuum, a small leak usually results in sap freezing in the surrounding tubing section which translates into a significant decrease in vacuum.
Maple Sap Vacuum Collection Systems Are Set Up Much Like A Tree.
Often cheaper to set up initially than buckets; 115 vac double diaphragm pump. Electric sap puller, single diaphragm pump.
A Vacuum System Must Be Capable Of Producing A Vacuum Of 15” Of Mercury At The Far End Of The Lateral Tubing For It To Be Considered Economical.
There are pumps out there that can run with either oil or water, and different pumps have different configurations. 15” of hg of vacuum = 5 psi change in pressure. A conventional 5/16” gravity system is not much different from running sap into a bucket.
This System Works With 3/16In Maple Sap Tubing And Is Suitable To Run A Modest Sized Pipeline In A Rural Area Lacking Access To Power.
Then, you’ll need a way to pump the sap out of your collection tanks and into your tank on your truck or gator that you’re using to transport the sap. Accommodates up to 800 taps. Large trunk lines branch off to smaller lines eventually branching off to a 5/16 id tubes that are attached to the trees for collecting the sap.
Comments
Post a Comment